#JACUZZI CONTROL PANEL HOW TO#
#JACUZZI CONTROL PANEL FULL#

Solution 4: Check for dirty filterĪ dirty filter doesn’t only affect the quality of the spa water but can also weaken the water flow. To open the air control/s open, simply turn them counterclockwise. These control/s are located on the top of the spa. Your spa’s jet system has its own air control or air valve. Press the Jets 1 button to make certain pump #1 is on. Other jets also offer an adjustable centre nozzle that allows you to change the water discharge angle. The water flow through certain jets in your spa can be adjusted or turned ON (open) and OFF (closed) by rotating the outside jet ring.

#JACUZZI CONTROL PANEL FULL#

Solution 1: Make sure jets are in the full open “on” position If the jets aren’t giving the pressure they typically would, you may follow the troubleshooting steps below.

#JACUZZI CONTROL PANEL HOW TO#

How to troubleshoot low flow or weak jets on a Jacuzzi ® J-200™ Collection Spa If the jets pumps operate and water is flowing through the jets, the problem is fixed. Once the power is back ON, press Jets Pump 1.

Make certain you reinstall the filter cartridge before turning on the spa power.

Step 3: Reinstall the filter cartridge then turn power the ON.

Then lift it straight up to remove it from the filter well. Remove the filter cartridge by rotating it counterclockwise to unthread it from the filter wall fitting. Remove the filter strainer lid assembly by rotating it counterclockwise. Turn power off and let the air out of spa plumbing system by removing the filter cartridge.

Step 2: Turn power the OFF and remove the filter cartridge.

Using the control panel press the JETS 1 button several times, never leaving the motor running for more than 5 to 10 seconds at a time.

Step 1: Press the JETS 1 button repeatedly.

To resolve this issue, please follow the steps below. This can happen after the spa is drained and refilled. If the jets are in the open position, it could be a failed water prime issue. Solution 3: The pump may not be properly primed Solution 1: Make sure the jets are in the OPEN position If after pressing Jets 1 button, the Jets pump 1 operates but there’s no water coming from the jets, please do the following. The main jets pump 1 operates but no water flows to the jets. Solution 3: If none of these fixes the problem, please contact Spa World™ Service to resolve the problem. You’ll know when the water level is acceptable when the water covers all jets but does not touch the bottom of the lowest headrest. If the water level is low, your pump may have trouble pumping water.

Resetting the breaker might fix the problem. Solution 1: Make sure power is going to the spaĬheck the circuit breaker and make sure that it is ON. If no water movement is detected, please do the following. When you press the Jets 1 button, the jets should start operating to circulate water through the jets which gives a massage-like effect to the users. No water movement after pressing Jets 1 button. There are several possible reasons the pump isn’t operating properly and most of them are easy to fix. How to troubleshoot Jacuzzi ® J-200™ Collection Spa if the pump doesn’t operate, but the light does

Jacuzzi control panel